High profile mag well for Polymer 80 frames. The low profile mag well adds 2mm of flared length to the end of your P80. This flare improves reloads and also improves grip.
These magazine releases are made out of nylon in a process called multi jet fusion. These parts are solid black and have an overall finish comparable to injection molded parts. These are strong enough to withstand anything you can throw at it.
Due to the manufacturing process these are only offered in black. If you are looking for other colors you can purchase our 3D printed option in several other colors.
The PF940v2, PF940C, & PF940CL mag well has been tested to work with the following magazines:
Glock Gen 3-5 15 & 17 round magazine
Magpul PMAG 15 & 17 round magazine
ETS 15 & 17 round magazine
The PF45 mag well has been tested to work with the following magazines:
Glock Gen 4 20 & 21 factory magazines
It may work with other magazine but the list above is all thats been confirmed.
These have not been designed or tested to fit on any standard Glock frames of any generation.
3 Reviews Hide Reviews Show Reviews
Works great on G19. It keeps your hand in the shooting postion. Looks good too.
Low profile magwell for Polymer 80
The fit is perfect! The finish is pretty good, but I would prefer the magwell to be smooth instead of the ridges. But, I'm ASSuming the ridges are structural due to the substrate. Overall...very well done.
Great product. Solid and cleanly made. Install was a bit tough because the fit was so tight. I find to be a good thing. The retaining screw seems to hold well. The only issue that I have run into was with an aftermarket mag extention made by another company. The retention screw for that extention was hitting the back of the magwel and not allowing it to seat properly. I wouldn't say this is a flaw in the Isle design, rather the cheap mag extention was poorly engineered. Over all 100% would buy again.